Add to Cart
The CPS171 is a resistive absolute pressure sensor solution with a fully calibrated pressure compensated analog output for low pressure applications, such as MAP (Manifold Absolute Pressure) systems.
The CPS171 solution comprises of an ultra-small resistive MEMS pressure sensor and a conditioning ASIC for accurate pressure measurements in factory calibrated ranges for the MAP applications. An integrated sigma-delta based ADC combined with internal calibration logic provides a high level analog output signal that is proportional to the applied pressure.
| PARAMETER | SYMBOL | CONDITIONS | MIN | TYP | MAX | UNITS |
| Over Pressure |
1000 (10) |
kPa (bar) |
||||
| Supply Voltage (with respect to GND) | VDD | -0.3 | 6.0 | V | ||
| Voltages at Analog I/O – In Pin | VINA | -0.3 | VDD +0.3 | V | ||
| Voltages at Analog I/O – Out Pin | VOUTA | -0.3 | VDD +0.3 | V | ||
| Storage Temperature | TSTOR | -50 | 130 | °C |
| PARAMETER | SYMBOL | CONDITIONS | MIN | TYP | MAX | UNITS |
| OPERATION | ||||||
| Supply Voltage to GND1 | VS | 4.75 | 5.0 | 5.25 | V | |
| Operating Temperature Range | -40 | 85 | °C | |||
| PRESSURE RANGE 1 CHARACTERISTICS (CPS171-JW001) | ||||||
| Range 1 |
10 (100) |
— |
115 (1150) |
kPa (mbar) |
||
| Full Scale Output | VFSO | @VS=5.0V | — | 4.7 | — | V |
| Full Scale Span | VFSS | @VS=5.0V | — | 4.5 | — | V |
| Accuracy | (0 to 85°C) | — | — | ±1.5 | %VFSS | |
| Sensitivity | V/P | — | 45 | — | mV/kPa | |
| PARAMETER | SYMBOL | CONDITIONS | MIN | TYP | MAX | UNITS |
| SUPPLY CURRENT | ||||||
| Update Mode Current | IDD | Worst Case Settings: 12-bit, 0ms Power Down | 1200 | 1500 | µA | |
| ANALOG OUTPUT | ||||||
| CPS171 | Analog_P |
10 to 115kPa |
0.4 | 4.65 | V | |
| Analog OUTPUT | ||||||
| Resolution | RES | 12 | Bits | |||
| Analog Additional Error (Including Ratiometricity Error) | Eout | -40 to 125°C | 0.1 | 0.5 | % | |
| SYSTEM | ||||||
| Trimmed System Frequency | fSYS | All Timing in this Specification are Subject to this Variation | 1.85 | MHz | ||
|
Start-Up-Time |
tSTA | Fastest and Slowest Settings | 4.25 | 173 | ms | |
| Update Rate (Normal Mode) | TRESP_UP | Fastest and Slowest Settings | 0.70 | 288 | ms | |
| Peak-to-Peak Noise @ Output (100 Measurements in 12-bit) | NOUT | 5 | LSB | |||